Vapecige VTX POD Kit – First Experience in AIO Kits
After a long break, Vapecige is back in service, and they returned not empty-handed. As you remember, they mainly specialize in boxing mods, both in simple and cheap plastic options, which especially fell into our brother’s wallet, and in low-cost variants running high-end chipsets. However, this time, the developers decided to relax, and roll out the AIO kit. Especially did not become philosophical, and contrary to the new-fangled tendency to shove chipsets from eminent manufacturers even in such devices, we limited ourselves to a no-name development, possibly our own.
Vapecige VTX POD Kit
These guys always had problems with the presentation of information regarding their products. And although they have an official website, you will not find almost any information there. I continue to not understand this attitude towards customers. I was waiting for the official release, naively believing that then I would get detailed TX, but alas, ah. As you understand, I am hinting that there will be a lot of unknown and obscure in this article. So just get acquainted with the appearance.
Dimensions: 80 x 30 x 20mm
Weight: unknown
Case material: plastic
Power: built-in, capacity unknown
Cartridge capacity: 2.5ml
Evaporator resistance: unknown
Operation mode: POWER
< Protection:from low / high resistance, from overheating, from short circuit, from overcharging / overdischarge
Connector type: magnetic
Screen / diagonal: no
Micro-USB port / charging: yes, charging current is unknown
Color: see photo below
Options (likely)
– VTX POD Kit
– replaceable cartridge (preinstalled)
– USB cable
– user manual
– warranty card
Our guest’s exterior is quite decent, these are small remnants. The developers focused on the streamlined form factor, I suggest that ergonomics should be decent.
From the start, just a lot of color schemes are offered, here anyone will find an option to their liking.
A replaceable cartridge of good capacity, it will refuel from the bottom – just remove the silicone plug.
Built-in ceramic evaporator. This whole structure is fixed with a magnetic connector.
Built-in battery of unknown capacity, I do not think that it will be decent. Presumably, the value will be within plus or minus 500mAh. The charging current, of course, is also unknown, probably a full charge cycle will take about an hour. The charging connector is visible at the bottom of the device.