Amodvape Valr RDA
Wow, I love to test newcomers to the vape industry, among them it’s rare, but really smart guys come across. And now I want to tell you about a pilot project of newly made sculptors of devices from the Middle Kingdom. By the way, they decided to start with the drip, and even with a purely lower blow. I admit, I haven’t met such people in a long time, even with nostalgia it smelled – the beginning of 2017 shows Tsunami Pro RDA on the table.
Case material: stainless steel Atomizer
type: RDA
Capacity: 1ml
Diameter: 24mm
Height: 30mm with drip type / 24.5mm without drip type
Connector: 510, pin is gilded
Weight: 43g
Color: see photo below
Options
– VALR RDA
– screwdriver key
– spare origins
– spare screws
– squonk pin
– coil trimming tool
– user manual
Thepackageisinteresting because you didn’t have any pre-punched stitches or cotton wool, but they threw the tool for trimming the coils and a special key. Yes, and the design is pleasant – a metal box. Something all this smacks of)))
Looking at the drip literally once, you will immediately understand where the legs are growing, or rather, as I put it earlier, than it smelled like that. Yes, the design is similar to the creation of a very eminent brand, but I have never indulged in this squabble, and I do not advise you. In general, the exterior is classic, there is not much decor, but what I would not say for sure is what it attracts. Yes – not bad, yes – decently, but no more. But I liked the color of my specimen, it is not metal or steel – it is gray, pleasantly matte gray.
Dryp type 810th, made of ultem, sits quite well. There are no chamfers to collect condensate on the inner surface. He is quite good at work, but he is very small in height, therefore your lips will fry, even despite the thick upper part of the dome. In addition, the colleagues in the shop – the other 810th drip types – all, as one, hang out inside. Perhaps it’s all about the origin at the landing site. Plus, most of my specimens could not sit here with the proper aesthetics – the landing site is very small.
The dome sits on the base movably, so it is problematic to twist the drip from the mod with damped orings. An obvious flaw, which is defeated in an elementary way – it is strange that the developers did not remember this. The risks on the dome are quite acute, but they will not be useful to you, because the adjustment is quite free. However, the dome sits normally – it does not hang out and even less so. The inner processing is spherical. Air intakes are paired, located at the very base. The puff turned out to be free, but not a direct draft, since on the deck the air is broken into three jets with small holes. And probably, due to the latter fact, it is quite noisy, and if you are impatient to cover two-thirds of the airflow, then the ear plugs will definitely come in handy. Fortunately, I was satisfied with the option of half-covered airflow.
The deck is quite simple, but there are nuances, maybe even innovation)
In its center, two massive racks with hexagon screws rise. The screws are massive, they know their business, and it is convenient to use a complete screwdriver. Holes of the lower airflow directly below each coil, the profile of the site is semicircular. There is not much space under cotton wool, but, as for me, enough.